| Mounting of ignition electrode |
| · |
Place tip of ignition electrode between clip and bracket. |
| · |
Push ignition electrode upwards. |
| · |
Position electrode tip in the hole on the top of the bracket. |
| · |
Push ignition electrode further upwards until the thickning passes |
| the hook of the bracket. |
| · |
Check spark gap to target. Spark gap must be between 2.5 and |
| 3.5 mm. |
Via Lago di Misurina, 76 - Z.I. - 36015 SCHIO-Italy - Tel. +39(0)445/678678 - Fax +39(0)445/678679 - |
E-mail: polidoro@polidoro.com |
Designed by AccaPi Studio S.r.l. |
| · |
Series |
| · |
Q 349A |
| · |
Q 359A |
| · |
Q 358B |
| · |
Aeration |
| IMPORTANT Installer must be a trained, experienced service person. Turn off gas supply before starting installation. An important requirement for the Q334A is that it must be installed correctly. Consult Honeywell application engineers when considering using these devices. Locating pilot burner |
| · |
Position for easy access and observation. |
| · |
Position so that pilot flame will not touch adjacent parts or main |
| burner flames. |
| · |
Position so that pilot flame will ignite main burner when pilot gas |
| pressure just exceeds safety shut--off value. |
| · |
Ensure that pilot flame has an ample supply of dust free air. |
| · |
Do not expose to draughts which will extinguish pilot flame or |
| deflect it from the flame sensingelectrode/thermocouple. |
| · |
Pilot burner should not extinguish when main burner is switched |
| "ON" and "OFF"'. |
| · |
Pilot burner shall be mounted in a preferably upright position. |
Pilot gas connection |
| · |
Square off end of tubing, clean, remove burrs and form it. |
| · |
With orifice assembly and compression fitting in position, insert |
| tubing into target spud until it bottoms and turn compression fitting finger tight. |
| · |
Hold tubing to prevent turning and tighten compression fitting with |
| a wrench about two turns beyond finger tight for 6 mm tubing and about 3/4 turn beyond finger tight for 4 mm tubing to make a pressure tight joint. |
| Do not use jointing compound. Do not bend tubing near fitting after tightening as this may result in gas leakage at connection. |
| Switch off power supply before making electrical connections. Wiring must be within local regulations. Follow the instructions supplied by the appliance manufacturer. |
| Mounting of thermocouple Insert thermocouple tip into thermocouple spud of pilot burner and tighten with the attached nut. Mounting of sensing electrode Insert flame sensing electrode into thermocouple spud of pilot burner and fix with gland. |
